Photocell Daylight Sensor
- Detects and identifies pre-programmed ambient daylight levels to turn on lights when needed, and to prevent them from turning on when the ambient daylight is above a certain level
- Upon detection of a pre-programmed daylight set point, sensor may be programmed to execute any Vision.net command accross the architectural control network
- User-friendly programming unit is available to configure the sensor without the use of ladders
- “Laser Painting,” a sensor with the laser pointer built into the remote, provides accurate sensor selection for programming
- Sensor can be programmed with a laptop PC as well as with a remote
- Status LEDs facilitate sensor programming
- Each sensor can be programmed to execute any Vision.net system command