Product Description
RDL RU-MLD4T Microphone / Line Distribution Amplifier - 1x4 with Transformer
Overview
The RU-MLD4 is a four channel audio distribution amplifier. The input and all four outputs may be connected through the front-panel XLR jacks or on the rear panel detachable terminal blocks. The input accepts either a balanced microphone or line level signal. Each of the four outputs provides either a microphone or line level signal. Both the front-panel XLR connectors and the rear-panel terminals are active at all times.
The audio input is equipped with a rear-panel switch to select between MIC and LINE level. Two additional switches allow setting the MIC input for LO or HI gain and for enabling or disabling standard 24 Vdc phantom. The two microphone gain settings allow the connection of a wide variety of dynamic and condenser microphones. Each output is provided with a separate rear-panel switch to set the associated level to either MIC or LINE. Audio outputs are isolated from each other and may be wired balanced or unbalanced. Gain trim is provided on a front-panel control. An RDL Dual-led VU meter is provided above the gain trimmer. The meter is calibrated to indicate +4 dBu for outputs set to line level. The rear panel provides a detachable terminal block and a power input jack to connect 24 Vdc power. Each output of the RU-MLD4T is equipped with a studio-quality audio output transformer.
Power Supply Not Included
Recommended Power Supply:
- PS-24AS (USA)
- PS-24AX (International)
Features
- Distribution Amplifier with Four Outputs
- Front Panel XLR Input / Output Jacks
- Detachable Input / Output Terminal Blocks
- Switch-selectable Mic or Line Input
- Switch-selectable Mic Gain and Phantom
- Gain Trim on Input
- Each Output Switch-selectable Mic or Line
Specifications
Inputs | 1 x Front-Panel XLR Connector 1 x Rear-Panel Removable Terminal Block |
Input Level | Mic/Line Switch-Selectable via Rear Panel |
Input Impedance | Mic: 2 k ohms Balanced, Switchable 24V Phantom Power Line: 10 k ohms, Balanced (May be Connected Unbalanced) |
Outputs | 4 x Front-Panel XLR Connectors 2 x Rear-Panel Removable Terminal Blocks (2 Channels on Each Block) |
Output Level | Mic/Line Switch-Selectable via Rear Panel |
Output Impedance | 150 ohms Balanced |
Gain | Mic: Off to 52dB (Lo), Off to 69dB (Hi) Line: Off to 15dB |
Frequency Response | Mic: 80Hz - 50kHz Line: 15Hz - 50kHz |
THD + N | Mic: Less than 0.1% Line: Less than 0.005% |
Common Mode Rejection Ratio | Mic: Greater than 60dB Line: Greater than 50dB |
Residual Noise | Mic: -79dB (50dB Gain), -70dB (60dB Gain) Line: -85dB |
Headroom | Greater than 20dB Above +4 dBu Line Output |
Power Requirements | 24 to 33 VDC @ 80mA (Can be input via Terminal Block or Power Input Jack) |