Product Description

Pathway Connectivity PWINF DIN D2A 16-Channel eDIN Demultiplexer (Old Part #1004)

The eDIN #1004 converts DMX512 to 16 channels of analog DC output voltage. Diode shunts allow user-selection between current sourcing applications—typically for theatrical dimmers—or current-sinking control—typically for LED fixture driver s or Mark VII electronic fluorescent ballast control. A non-dim mode  supports solid-state relay control.

Features

• DMX512 start address and operating mode may be set from front panel interface or remotely using E1.20 RDM
• Indicator LEDs for power, processor, and DMX input status
• Standard DC output modes of 0-10V, 0-15V, 0-2.5V, or 0-5V
• Custom mode allows user-set minimum and maximum DC output up to 16V
• EFBC/LED Driver mode allows single DMX channel control of mains voltage (via SSR) and 0-10V dimming
• Maximum current rating per output of 10mA (sourcing) or 30mA (sinking)
• CCL “Panic Input” drives all outputs to full
• Pluggable terminal block connections accept solid or stranded wire between #26 and #16 AWG
• One DMX512-A/RDM data input connection
• One passive DMX512-A data through connection
• Data and power easily daisy-chained between modules
• Termination switch
• Firmware field-upgradable using RDM (requires Pathway Pathport gateway and RDM utility program)

Included

• DIN tray (housing) with end caps
• 11” (280mm) x 35mm DIN rail
• Installation/Operations manual

Modes

• 0 - 10VDC Output
• 0 - 5VDC Output
• 0 - 015VDC Output
• 0 - 2.5VDC Output
• Custom Output - user set MIN and MAX output levels between 0 - 16VDC
• Electronic Fluorescent Ballast/LED Driver Control (10% threshold)
• Non-Dim
• Electronic Fluorescent Ballast/LED Driver Control (1% threshold)

Specs

• 1500V opto-isolation between input and output ports
• 250V fault protection on input and output ports
• Input operating voltage: 9-30 VDC
• 6W power consumption
• Operating conditions: -10°-50°C; 10-90% relative humidity, non-condensing
• 0.70 lbs (0.316 kg)
• 3.6”W x 6.25”L x 1.5”H  (91mm x 160mm x 38mm)
• Compliance
• ANSI E1.11 DMX512-A(2008)/USITT DMX512(1990)
• ANSI E1.20 RDM(2010) - Remote Device Management
• ANSI E1.3  0-10V Analog Control (with diodes shunts on)
• ANSI C82.11 Fluorescent Ballast Control (diode shunts off)
• RoHS 2011/65/EU
• Class 2 Low Voltage

Accessories