Product Description
Pathway Connectivity PWINF DIN A2D Analog-to-DMX 24-Channel eDIN Demultiplexer (Old Part #1006)
The eDIN #1006 converts 24 analog 0-10VDC sources or 24 dry contact closures into a DMX512 signal. A built-in DMX merger combines signal output with other in-line #1006 interfaces, lighting consoles or controllers. Also may be used as a simple snapshot playback device, holding up to 24 ‘looks’.
Features
- DMX512 start address and operating mode may be set from front panel interface or remotely using E1.20 RDM
- Indicator LEDs for power, processor, DMX input status and contact closure operation
- Convert 0-10VDC input to DMX512 output levels
- Alternate contact closure mode, for off/full DMX control
- Recall mode allows capture and playback of up to 24 discrete, full universe ‘looks’
- LED indicator for CCI mode
- Built-in merger allows in-line operation with other DMX sources in either recall or input modes
- One DMX512-A/RDM data input connection
- One passive DMX512-A data through connection
- Data and power easily daisy-chained between modules
- Termination switch
- Independent test function, in both analog and contact closure modes
- Firmware field-upgradable using RDM (requires Pathway Pathport gateway and RDM utility program)
Included
- DIN tray (housing) with end caps
- 11” (280mm) x 35mm DIN rail
- Installation/Operations manual
Modes
- Highest Takes Precedence (HTP)
- Analog Takes Precedence
- DMX Takes Precedence
- Contact Closure Input
- Preset Recall
- DMX Takes Precedence over Preset Recall
Specs
- 1500V opto-isolation between input and output ports
- 250V fault protection on input and output ports
- Input operating voltage: 9-30 VDC
- 6W power consumption
- Operating conditions: -10°-50°C; 10-90% relative humidity, non-condensing
- 0.70 lbs (0.316 kg)
- 3.6”W x 6.25”L x 1.5”H (91mm x 160mm x 38mm)
- Compliance
- ANSI E1.11 DMX512-A(2008)/USITT DMX512(1990)
- ANSI E1.20 RDM(2010) - Remote Device Management
- ANSI E1.3 0-10V Analog Control
- RoHS 2011/65/EU
- Class 2 Low Voltage
Accessories
|
1001-050-24-DIN |
50 Watt, 24VDC Power Supply, DIN-Mountable |
|
1001-100-24-DIN |
100 Watt, 24VDC Power Supply, DIN-Mountable |
|
1103 |
eDIN Rack Mount Panel, |
|
1105 |
eDIN System Enclosure, 10" x 13" x 4.5" |
|
1106 |
eDIN System Enclosure, 10" x 23" x 4.5" |
|
1107 |
eDIN System Enclosure, 10" x 23" x 4.5" |
|
1108 |
eDIN System Enclosure, 10" x 13" x 4.5" |
|
1109 |
Expanded eDIN System Enclosure 18.5" x 31.5" x 6.5" |
|
4000 |
eDIN Enclosure Assembly Service |
