Product Description
Lightronics TL4008 16 Channels, 8 Scenes Optional DMX (5 pin or 3 pin)
| The TL4008 lighting control console is suitable for church, stage, theater, disco, night club, live performances and other event and artistic applications. |
Specifications
|
Specifications
- Number of channels 16 or 8 depending on mode
- Operating modes 8 channels x 2 manual scenes 16 channels x 1 manual scene 8 channels and 8 recorded scenes
- Scene memory 8 scenes total
- Chase 2 programmable 40 step chases
- Control protocol LMX-128 (multiplex) USITT DMX-512 is optional
- Output connector 3 pin female XLR connector 5 pin female XLR for DMX-512
- Compatibility Multiplex protocol compatible with other multiplex systems
- Power input 13VAC or +15VDC
- Optional external power supply
- Dimensions 10.25”W x 9.25”D x 2.5”H
Architect & Engineer’s Specifications
The lighting control console shall have one manual 24 channel scene; two manual 12 channel scenes; or one 12 channel manual plus 192 preset programmable scenes accessible in 12 memory banks. The operation is selected by a MODE switch. Split crossfader control enables full manual fade between scenes. Momentary (bump) buttons enable instant channel turn on in either a Pile On or Solo selectable mode. Twelve 20 step chases and will chase channels, scenes or a combination of both and are user programmable. A built in microphone can also activate chase steps. There shall be a fully functional Cue Stack function with up to 240 cues, each with programmable FadeIn/FadeOut times up to 99 seconds. Cues are activated via a “GO” button. The console has a Softpatch function and can store two patches in the onboard memory. There shall be an overall master fader, blackout function, and control of the chase rate. The console shall have a nonvolatile memory to retain scenes and chases when powered off. The console is supplied standard with LMX128 (multiplex) control on a 3 wire cable and DMX512. The power requirements for the console shall be in 3 wire multiplex mode: 18VAC or +15VDC, 400 ma minimum; and/or when DMX512 is being used an external power supply is needed: 13 - 25VAC or VDC, 400ma minimum. Construction is of 16 gauge steel and no rivets are used in the construction. Nylon “break resistant” shafts are used on the fader controls. The console is 16.25”W x 9.25”D x 2.5”H and the weight is 6.8 pounds. The lighting control console shall be a Lightronics TL5024.
