Product Description
Lightronics AS62DC Portable Dimmer 6 Channels, 1200W per Channel
| The AS62DC is a compact 6 channel light dimmer with Circuit Breakers. It has a maximum capacity of 1200 Watts per channel and maximum total load capacity of 4800 Watts. It is supplied with 2 input power cord stubs which may be connected to 2 different 120 VAC power phases. The unit operates using the USITT DMX-512 protocol or an industry standard three wire multiplex protocol. The AS62D may be operated in a relay (non-dim) mode. The unit will also function as a chaser and has several preset chase patterns which may be used. |
Specifications
|
The AS62D is a compact portable 6 channel light dimmer. It has a maximum capacity of 1200 Watts per channel and maximum total load capacity of 4800 Watts. It is supplied with 2 input power cord stubs which may be connected to 2 different 120 VAC power phases. The unit operates using the USITT DMX-512 protocol or an industry standard three wire multiplex protocol. The AS62D may be operated in a relay (non-dim) mode. The unit will also function as a chaser and has several preset chase patterns which may be used.
Specifications
- Channels: 6
- Channel Capacity: 1200 Watts per Channel
- Total Power: 4800 Watts
- Control Protocol: DMX-512 and 3 Wire LMX-128
- Control Connections: Dual 5 Pin XLR, DMX Dual 3 Pin XLR, LMX
- Power Requirements: 120VAC, Two 20 Amp Circuits
- Power Input: Two Edison Plugs
- Frequency: 50 or 60Hz
- Fusing: 10 Amp each Channel
- Preheat Voltage: Soft Start Control
- Response Curve: Modified Square Law
- Filter Rise Time: 350 Microseconds
- Filter Max. Rate of Rise: 105 Milliamps / Microsecond
- Response Time: 8.3 Milliseconds
- Full Load Voltage Drop: 3 Volts
- Conduction Angle Range: 180 Degrees
- Efficiency: 97%
- Size: 13.5”L x 8.5”W x 3 3/8”D
- Weight: 8.5 Pounds
Architect & Engineer’s Specifications
The dimming system shall have 6 circuits with a load capacity of 1200 Watts per circuit. Each circuit is protected by a 10 Amp fast acting magnetic circuit breaker or a 10 Amp fuse. An allowance of 200% overhead capacity is employed in the circuit design. The dimming system shall have a rise time of not less then 350 microseconds. Setup attributes of Dim or Relay, and unit address via the dipswitch controls. The dimming system shall use the USITT standard DMX-512 protocol for direct control of the dimming circuits and/or the Lightronics LMX analog multiplex protocol. Power requirements of the dimming system shall be 120/208 VAC Single Phase or dual single ended operation, capacity shall be 20 Amps per leg. Load output connectors shall be a user selections of Edison or Stagepin style connector. Input electrical connections are made through 2 pigtails with connectors determined when purchased. The dimming system is to be mounted using standard lighting equipment clamps. Dimensions are 13.5”L x 8.5”W x 3 3/8”D; the weight shall be 9 lbs. The dimming system shall be a Lightronics AS62D.
