Product Description
ILC DIM-Z Tempo Dimming Interface Module 0-10V Control of ELV Load - 600W/120V, 1350W/277V
Tempo’s Dimming Interface Module converts a 0-10V dimming signal to an Electronic Low Voltage (ELV) dimming output to control fixtures with ELV drivers. One DIM-Z is required per run up to a maximum of 600W (120V) or 1,350W (277V). DIM-Z does not affect the dimming characteristics of the fixture driver. For example, if using a driver that dims to 5% it will still dim to 5% when using the DIM-Z to convert 0-10V to ELV signal. NOTE: 5 year warranty only valid when used with Tempo fixtures. Limited warranty when used with non-Tempo fixtures. Any testing for compatibility between the DIM-Z and all non-Tempo fixtures is the sole responsibility of the customer. Tempo assumes no liability for malfunctions or defects when DIM-Z is used with fixtures other than Tempo’s. Contact Tempo for more information on testing other fixtures with DIM-Z and lead times for high volume orders
FEATURES
- Made in the USA
- 0-10V dimming control of ELV loads
- 120/277VAC Compatible
- 600W@120V, 1350W@277V
- Plenum rated
SPECS
Performance:
• 120-277VAC Universal line voltage. 50/60Hz
• 0-10V dimming input converts to Electronic Low Voltage (ELV) signal via microprocessor based controller.
• 600W Max(120V), 1,350W Max (277V)
• One DIM-Z per fixture run
• Operating temp range of -20°C to 50°C
• Tempo recommends using surge suppression devices on each circuit to protect DIM-Z and fixtures.
Construction:
• Aluminum housing with extruded aluminum heatsinks
• 48" wire leads, 16 gauge, with 36" flex conduit
•self-diagnostic fault indicator
• CSA dry location listed
• Plenum rated