Product Description
ETC D20FB Single 20A Fluorescent/Battery Module
The Fluorescent Module is a single, plug-in dimmer with an additional constant-current output for us in Unison Dimming Series enclosures. The Fluorescent Battery Module provides one circuit of forward-phase angle dimming control for 2-1ire dimming ballasts and one non-dimmed power circuit for an integral emergency lighting battery pack located in remote fluorescent lighting fixtures. Bothc circuit outputs are controlled under a single breaker for code compliance. The patented design features high-density, modular assembly, fully-magnetic circuit breaker, and electronic low-end set controls.
APPLICATIONS • For Use in 100-120V Unison DRd enclosures • 2-wire fixtures with integral emergency battery pack
FEATURES • One 1.8kW or 2.4kW circuit per module • Modular assembly • Die-cast aluminum chassis • Fully magnetic circuit breakers
GENERAL • 100,000A Short Circuit Current Rating (SCCR) • UL and cUL LISTED
ORDERING INFORMATION 100-120 Volt Fluorescent Battery Dimmer Modules
MODEL DESCRIPTION
- D15FB Single 15A Fluorescent Battery Dimmer Module
- D20FB Single 20A Fluorescent Battery Dimmer Module
Compatible Systems*
MODEL DESCRIPTION
- DRd6-12-120 100-120V 6 module rack enclosure (12 circuits)
- DRd12-24-120 100-120V 12 module rack enclosure (24 circuits)
- *Rack enclosures also available for 277 Volt applications
SPECIFICATIONS
GENERAL • Single density, plug in modules, for use in Unison Dimming Series rack enclosures • UL and cUL Listed for continuous duty at 100% of rated load - D15FB – 1.8kW - D20FB – 2.4kW
PHYSICAL • Modular plug-in assemblies • Cast aluminum chassis, finished with textured epoxy paint
CIRCUIT BREAKERS • Fully magnetic to eliminate nuisance tripping • 20x inrush current rating • 125%, 10-120 seconds, must-trip rating • Rated for 100% switching duty applications
ELECTRICAL RATINGS • 100,000A Short Circuit Current Rating (SCCR) • Replaceable fuse on both the switched and the dimmed AC circuit for short circuit protection and fault current coordination • Modules withstand hot-patching of cold loads up to full rating • UL and cUL
LISTED POWER DEVICE • Sealed, patented assembly • Field replaceable with screwdriver • Two back-to-back SCRs per circuit • One control LED per circuit • 4000V isolation between control and power components • Integral bonded heatsink
DIMMER RANGE • Incandescent, low voltage dimming range 100-0% • Dimming range of 2-wire fluorescent ballast is dependent on lamp ballast combination. Contact ETC for range verification