Product Description
ETC AD20F Single 5.5KW 3-wire Fluorescent Module - 277V, Repair
Part# 7083A1009
| 1. This is for the repair of an existing item. |
| 2. Once you place your order, then we will email you with an RMA# and shipping instructions so that you can ship your item out for repair. |
| 3. Please note that it may take up to 1-business day for us to send you the RMA# and shipping instructions. |
| 4. You will pay for the cost of outbound shipping on the repair. You can also decide the speed at which you want to ship the item out for repair. |
| 5. Please provide us with any technical notes about the issues that you are having with this product, so that they can be address during the repair of the unit. |
| 6. The repair will take approximately 1-2 weeks from the date of receipt of the item. |
| 7. The repaired unit will then be shipped back to you via the outbound shipping method that you select with this order. (Free, Ground, 2-Day, Overnight). |
| 8. Please call us at 1-866-457-5937 for any technical support questions. |
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
The Fluorescent Module is a single, plug-in dimmer for use in Unison Dimming Series Enclosures. The Fluorescent Module provides cost-effective digital forward phase angle dimming of 3-wire fluorescent dimming ballasts. The patented design features high-density modular assembly, fully magnetic circuit breaker and electronic low-end set controls.
Features:
- High-density modular assembly
- Die-cast aluminum chassis
- Fully magnetic circuit breaker
- Electronic low-end set controls
Specifications:
GENERAL
• Single density, plug in assembly, for use in Unison Dimming Series rack enclosures
• UL and cUL Listed for continuous duty at 100% of rated load
- AD15F – 4.1kW
- AD20F – 5.5kW
PHYSICAL
• Cast aluminum chassis, finished with fine textured epoxy paint
CIRCUIT BREAKERS
• Fully magnetic to eliminate nuisance tripping
• 20x inrush current rating
• 125%, 10-120 seconds, must-trip rating
• Rated for 100% switching duty applications
ELECTRICAL RATINGS
• 65,000A Short Circuit Current Rating (SCCR)
• Replaceable fuse on both the switched and the dimmed AC circuit for short circuit protection and fault current coordination
• Modules withstand “hot-patching” of cold fluorescent loads up to full rating
• UL and cUL LISTED
POWER DEVICE
• Sealed, patented assembly
• Field replaceable with screwdriver
• One control and one output LED
• 4000V isolation between control and power components
• Integral bonded heatsink
• Integral temperature sensor
DIMMING RANGE
• Dimming range dependent on lamp-ballast combination. (Contact ETC for range verification)
Ordering Information
277 Volt Fluorescent Modules
Model Description
- AD15F Single 15A Fluorescent Module, 277V
- AD20F Single 20A Fluorescent Module, 277V
Compatible Systems*
Model Description
- DRd6-12-277 240V 6 module rack enclosure (12 circuits)
- DRd12-24-277 240V 12 module rack enclosure (24 circuits)
* Rack enclosures also available for 100-120, 230 and 240 Volt applications
SCR Rating
Module AD15/20F
- Single cycle peak surge current 625As
- Half cycle peak surge current 1620A
- Transient over voltage 600V
