Product Description
Doug Fleenor Design NODE 1-P 1-Port Ethernet to DMX Portable Interface
The NODE1 is a single gang wall mount Ethernet to DMX interface. It has zero boot time and accepts E1.31 sACN, draft sACN, Art-Net, Strand ShowNet, or KiNET. The single DMX port can be configured as either an input or output. Configuration is done using any web-browser (Internet Explorer, Firefox, Safari, Chrome, etc.). Powered by Power over Ethernet (POE), the NODE1 requires only a single cat5 cable for power and signal.
Specs
Power input: Power over Ethernet, POE (802. 11af), 3W
Color: Black
Size and weight:
- Faceplate: 4.5”H × 2.75”W
- Rear: 2.75”H × 1.7”D × 1.6”W, ½ pound
Min box size: 3.875”H × 2.75”D × 1.75”W
Ethernet Specs
Ethernet circuit: 100BASE-TX Fast Ethernet, MDIX, and Auto Negotiation
Network protocols: E1.31 sACN, draft sACN, Art-Net, Strand ShowNet, KiNET
Connector: RJ45
Isolation: 1500 Volts
DMX Port Specs
DMX circuit:
- EIA-485 transceiver with 120 ohm fail-safe termination between Data+ and Data-
- NOTE: This product uses slew-rate-limited output drivers. Slew-rate-limited drivers minimize EMI and reduce reflections.
Input signal: 0.2 Volts minimum, 12 Volts maximum
Output signal: 1.5 Volts (minimum) into 120 ohm termination
Connectors: Gold plated 5 pin XLR (typically female connector, male on request)
Port protection: +60V continuous, +15KV transient
