Product Description
Doug Fleenor Design FT-5 XLR Feed-Thru Assembly Panel Mount With 5 Pin XLR
Overview
The Splitter/Amplifier provides between one and eleven DMX512 outputs from a single DMX512 input. The outputs are electrically isolated from the input and from each other by 2500 volt optical couplers. All models of our Splitter/Amplifier boost the signal as well as isolate it. Input levels as low as 0.2 volts are transmitted at full EIA-485 levels (about 4.5 volts). The splitters allow the DMX signal to be split without the possibility of reflections from one signal path interfering with the signal to a device on a different path. By isolating each output, electrical noise and hazardous voltages on one output are prevented from affecting (or damaging) devices on the input or another output.
Features
- Outputs are isolated from each other
- Uses 2500 Volt optical couplers
- Power and input signal indicators
- 60 mA drive current
Specifications
Input circuit: EIA-485 receiver with 120 ohm termination resistor between +Data and -Data (Units with feed through connectors do not have internal termination)
Input signal: 0.2 volts minimum, 12 volts maximum
Output circuit: EIA-485 driver
Connectors: Gold plated 5 pin Neutrik D-1 Series (3 pin connectors, terminal blocks, or RJ45 optional)
Feed through: A non-isolated feed through connector is standard on the eleven output model and is optional on the one, three, and five output models.
Isolation: 2500 volt optical coupler, 1500 volt split bobbin transformer
Power input: 100 - 120 volts, 50/60 hertz, 12 watts (208 - 240 volt optional)
Color: Top, bottom and sides: Silver hammer tone Front and back: Black
