Product Description
Doug Fleenor Design DMX2iPLAY DMX to iPlayer Interface
The DMX512 iPlayer 2 interface receives a DMX512 input signal and outputs RS-232 commands to the iPlayer. The interface uses three consecutive DMX512 channels: Trigger mode, Show selection, and Global intensity.
The interface is compatible with iPlayer 2 and Light System Engine which are both products (and registered trademarks) of Color Kinetics Incorporated.
Specs
Input baud rate: 250 Kb/s
Input circuit: ESD protected EIA-485 transceiver (LT1785)
Input signal: 3 volts minimum, 12 volts maximum
Input connector: Gold plated 5 pin XLR (Neutrik D-1 series). Pin 1 = common, Pin 2 = Data-, Pin 3 = Data+
Through connector: Gold plated female 5 pin XLR (Neutrik D-1 series). All pins wired through.
DMX profile: 3 consecutive channels (trigger mode, show selection, global intensity)
Output baud rate: 9600 bps, 8 data bits, no parity, 1 stop bit
Output circuit: RS-232 driver (MAX232). Outputs are short circuit protected but not over voltage protected
Output signal: RS-232 driver yields an approximate +/- 10 volt signal
Output connector: DB9 (male) Pin 2 = Receive, Pin 3 = Transmit, Pin 5 = signal ground. (straight DB9 Male to Female, cable provided)
User interface: Start address set via a three digit thumbwheel switch
Indicators: Red power LED, Green DMX signal LED, Green RS-232 transmit LED
Power input: Universal power supply 100 - 240VAC, 50/60 hertz, 5 watts
Color: Black anodized
Size and weight:
- Chassis 5.3"l X 3.2"w X 1.8"h, 12 ounces
- Power supply 2.2"l X 1.9"w X 1.0"h, 5 ounces
