Product Description
Audix ADX10FL Wireless Miniaturized Condenser Flute Microphone
The ADX10FL is characterized by a uniformly controlled cardioid polar pattern, helping to isolate the area or section being miked from other instruments or vocals on stage. With a smooth and accurate frequency range of 50 Hz – 18 kHz, the ADX10FL is lightweight, low profile, and will provide natural sound with an exceptional transient response.
The ADX10FL cardioid condenser microphone works with the Audix wireless systems specifically for use with a flute, includes a clip that attaches to the headstock of a flute, an 8’ cable terminating to a miniXLRf connector.
Manufactured to high standards and tight tolerances, the ADX10FL miniaturized condenser flute microphone features a modular threaded capsule, machined brass body with a matte black finish, high-quality shielded microphone cable, and a variety of optional accessories.
Designed, assembled, and tested by Audix in the USA.
MODEL VARIATIONS
ADX10FL - Same as ADX10FLP without the APS911 phantom power adapter
SUPPLIED ACCESSORIES
- MCFLUTE - Clip for ADX10FLP flute mic. Fits standard size flutes.
- WS10 - External foam windscreen for reducing wind, sibilance, and pop noise
- P1 - Carrying pouch
- APS911 - Optional phantom power adapter for use with electret condenser microphones. Runs on AA batteries when phantom power is not available. Features on/off switch and bass roll-off filter.
OPTIONAL ACCESSORIES
- MC10L - Optional alligator style lapel clip with spring tension wire loop.
- APS910 - 48 V phantom power adapter for use with electret condenser microphones.
FEATURES
- Miniature condenser flute microphone
- Natural, accurate sound reproduction
- May be used wired or with RAD360 Wireless System
- Designed, assembled & tested in the USA
- 3 year warranty
APPLICATIONS
Flute (Standard size)
SPECIFICATIONS
Transducer Type | Pre-Polarized Condenser |
Frequency Response | 50 Hz – 18 kHz |
Polar Pattern | Cardioid |
Output Impedance | 250 ohms |
Sensitivity | 4.5 mV / Pa @ 1k |
Equivalent Noise Level | <29 dB (A-weighted) |
Signal to Noise Ratio | >65 dB |
Maximum SPL | ≥120 dB |
Power Requirements | 5-52 V phantom |
Connector | Shielded 3’ terminating to a minature 3 pin XLRf |
Polarity | Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 |
Materials / Finish | Machined Brass Capsule / Black Finish |
Weight | 110 g / 4 oz |
Length | 25 mm / 0.98 in |