Leviton Colortran iSeries i48E/96E Quad Control Module, new.
Colortran I Series "e" Control Module for the I48e and/or I96e dimmer rack.
Dimmer rack requires one control module, but if two modules are installed; second control module can act as a backup unit.
The control module contains nearly all of the control electronics and generates the necessary control signals and power necessary to control the dimmers in the rack. There are 2 different control modules for i series e and i series quad. · The i96/48 control module (CTP-0311e) controls i96e, i48e or i48Quad dimmer racks in all configurations. · The i24 control module (CTP-0313e) controls i24 dimmer racks in all configurations. Control modules are completely interchangeable within the i series e and i series quad system, as long as they are the same type of control module as detailed above. The only selection that makes a control module unique is the thumbwheel address setting on the front of the control module. All other individual parameters for the rack are stored in the socketed serial EEPROM chips on the i series e backplane. On power up, the control module automatically loads all the unique information from the serial EEPROMS on the backplane, determines the line frequency, and phase angle firing assignments. The top pair of chips in a 16 pin DIP socket (P5) permanently store all the unique information for the upper control module position. The bottom pair of chips in a 16 pin DIP socket (P6) permanently store all the unique information for the lower control module position. The unique information that is stored is the configuration parameters of the control module itself, backup looks, analog submaster scenes, the panic scene, and the custom patch. Standard patches are available by setting the address number in the range of ‘1 ‘to ‘15’. Setting the thumbwheel to ‘0’ invokes the custom patch stored in the EEPOMS on the backplane.